Headlight Care Spray for Clear Surfaces

Yellow headlights that barely shine at night – and the next oncoming traffic still blinds you.

Who doesn’t know this: You drive at night and notice that the road ahead looks gray and blurry – not because of your eyes, but because of the milky yellow layer on the headlight lenses. The LumaShield Kit dissolves this oxidized layer using a spray-and-wipe method, no sanding, no removal, and no workshop appointment needed. After about 15 minutes per headlight, the lenses shine like fresh from the factory – and the UV protection layer keeps the clarity throughout the entire season.

Advantages

• No more hours of sanding efforts: Other kits require three stages of sandpaper – one slip-up and the lens looks worse than before. With this spray, the oxidation dissolves on the first wipe with the cloth, no abrasive grit, no risk.
• No workshop, no maintenance day: Instead of handing over the car and spending Saturdays in the service queue, you can restore both headlights directly on your driveway – the kit covers a complete pair including reserve product for touch-ups.
• No re-yellowing after a few weeks: The applied sponge-based UV protection dries evenly and prevents UV radiation from breaking down the lens again in summer – no aerosol overspray on the paint.

Specifications

• Restoration spray: 120 ml / 4 fl oz
• Protective sealant: 10 ml / 0.34 fl oz
• Microfiber polishing cloth: 20 cm × 20 cm
• Application sponge: Dual-density, approx. 3 cm × 1.5 cm × 7 cm
• Active ingredients: Isopropyl alcohol, propylene glycol methyl ether, fatty alcohol polyoxyethylene ether-9
• Coverage: A complete pair of headlights (sedan/SUV) with reserve quantity
• Compatibility: Polycarbonate lenses of nearly all modern vehicles

Application

1. Clean: Wash the headlights with water and soap, let them dry completely.
2. Restore: Evenly apply the spray to the lens, wipe back and forth with the microfiber cloth until the yellow layer transfers to the cloth, then rinse with clean water and dry.
3. Seal: Put a few drops of protective sealant on the sponge, wipe it in one direction over the dry lens, and let it dry in the air.

Pro tip: Masking off the surrounding paintwork with painter’s tape allows for even more relaxed work – any overspray can also be easily wiped off the paint with a damp cloth.